husa schimbator maneta cutie de viteza

[nnd 0]

Am un S40 1,8 benzina din 1999 si as vrea sa stiu cum se poate demonta husa din inlocuitor piele de la maneta schimbatorului, deoarece cea veche s-a rupt si nu ma descurc sa o scot la partea superioara adica unde vine nuca schimbatorului.Are cineva idee cum se scoate ?? Eventual o schema ceva .Multumiri anticipate

[mihai_s40 1]

in partea de jos , pe dedesupt , e intarita cu un plastic, pe care sunt clemele. incearac sa tragi in sus exact de plasticul ala , cu tot cu husa aia, si sare din cleme

[nnd 0]

in partea de jos stiu cum se desface. e simplu dar nu ma descurc in partea superioara, unde vine nuca pe care pui mana cand schimbi viteza

[mihai_s40 1]

rupe-o ca tot o schimbi.  nuca tre sa iasa cumva, adr iti zice altu mai curios, ca eu pe aia nu am scos-o

[nnd 0]

mai astept pareri si eventual vreo schema de la cine are vadis

[casmin 1]

Cam asta scrie in VADIS:

Replacing gear selector lever knob and boot

Special tools: 999 5685

Remove boot from center console panel

Press the frame inside the boot in the rear edge and at the sides. Lift up the frame with boot from the panel.

Slacken off boot from gear selector lever

Position drift 999 5685  under boot. Press the drift up, with a twisting movement, so that the lugs on the boot sleeve is released.

Depress boot and remove drift.

Remove gear selector knob

Position drift 999 5685  under gear selector knob. Press up the drift and twist in both directions so that the lugs on the knob are released. Pull off knob from drift.

Note! If the boot is to be replaced remove it from the gear selector lever. Use drift 999 5685 .

Position drift according to Slacken off boot from gear selector lever .

Install gear selector lever boot

Locate guide lug on the boot ring in the guide track on the lever.

Depress the ring to the lower lock groove.

Note! If the boot has not been replaced pull it up in its lock groove.

Secure the boot in the center console by first pressing the hooks into place on the front edge.

Then press the snap grips into place on the side and rear edges.

Install gear selector lever knob

Locate guide lug on the knob in the guide track on the gear selector lever. Press it into the lock groove.

cam asta scrie si sper sa-ti fie de ajutor....am atasat si pozele din VADIS....sa-ti fie mai usor

[nnd 0]

MULTUMESC MULT DE TOT.

[casmin 1]

ma bucur ca ti-a folosit

[nnd 0]

totusi nu  am reusit sa dau husa jos la partea superioara. In acele explicatii nu se face referire la demontarea in partea de sus sau poate nu o fi de la modelul meu de schimbator .O sa atasez si o poza.